Retailers sell sheetrock joint compound as a premixed product or as a powder that you mix with water. The premixed product is convenient because it does not require mixing, but a lot of professionals still mix it until they use it. Mixing removes a number of the stiffness and makes it much easier to disperse. For final coats, a few add a little bit of water to the compound whilst mixing. Powdered blends have a comparatively short working time, but let the use of additional coats of compound the identical moment.
Premixed Compound
Install the drywall compound mixing paddle at the drill and then tighten the chuck. Insert up to 3 liters of compound to the 5-gallon bucket for mixing. Stand over the bucket of compound using a foot on either side and maintain the bucket along with your toes.
Set the drill speed switch to low if the drill has two speed settings. Hold the drill with both handson. With the close of the paddle completely inserted into the drywall compound, slowly squeeze the drill trigger to begin the paddle turning.
Thoroughly mix the sheetrock compound until it’s a smooth, creamy feel. Publish the drill trigger to prevent the drill.
Add as many as 2 ounces of water per gallon of sheetrock joint compound to thin it to the final coats. Begin the drill and mix the compound until the water is fully integrated into the mixture. Stop the drill and remove the paddle in the compound.
Dry Mix Compound
Read the manufacturer’s instructions on the amount of water to add to the package and for your slake time. Slake time is the short period, usually a few minutes, after originally mixing the compound when the compound reacts with water.
Measure the minimum amount of water required and add it to the 5-gallon bucket. Put the difference between the minimum and maximum amount of water in the measuring pail. Open the package of compound mix and add it to the water.
Stand over the skillet and hold it together with your toes. Insert the paddle into the skillet and squeeze the drill trigger to start the paddle turning gradually. Maintain the paddle turning gradually until the dry mixture is integrated into the water.
Boost the drill speed to mix the compound to a smooth creamy texture. Add 1 to 2 ounces of water to the mixture if necessary and continue mixing until a smooth, creamy mixture that spreads readily is obtained.
Quit mixing but do not remove the paddle in the compound. Wait the specified slake time, then remix the compound for two to four minutes, according to the instructions. If the mixture is too stiff, add a small amount of water and remix.